--- title: "Setting up site-to-site on Cisco Meraki" slug: "site-to-site-cisco-meraki" description: "This article describes how to configure a site-to-site connection between NordLayer dedicated server and Cisco Meraki device using the management interface." updated: 2026-09-08T13:11:07Z published: 2026-09-08T13:11:07Z canonical: "help.nordlayer.com/site-to-site-cisco-meraki" --- > ## Documentation Index > Fetch the complete documentation index at: https://help.nordlayer.com/llms.txt > Use this file to discover all available pages before exploring further. # Setting up site-to-site on Cisco Meraki **Note**: If your device/service supports SHA256 and DH group 14, it is recommended to use these settings instead. This article describes how to configure a site-to-site connection between NordLayer server with a dedicated IP and Cisco Meraki device using the management interface. You must replace the example values in the procedures with the values that are provided in the configuration file. ## Adding a new VPN site 1. Go to the Non-Meraki VPN peers section in Security Appliance > Configure > Site-to-site VPN page 2. Select Add a peer and enter the following information: - **A name for the remote device or VPN tunnel**: NordLayer - **The public IP address of the remote device**: Public IP Address of your NordLayer dedicated server - **The subnets behind the third-party device that you wish to connect to over the VPN**: 10.6.0.0/20 - **The IPsec policy to use**: Select Custom and enter the following information: ### Phase 1: - **Encryption**: Select AES-256 encryption - **Authentication**: Select SHA1 authentication - **Diffie-Hellman group**: Select between Diffie-Hellman (DH) groups 5 - **Lifetime (seconds)**: 28800 ### Phase 2: - **Encryption**: Select AES-256 encryption - **Authentication**: Select SHA1 authentication - **PFS group**: Select group 5 to enable PFS using that Diffie Hellman group. - **Lifetime (seconds)**: 3600 - **The pre-shared secret key (PSK)**: Enter the PSK you generated (we will also need this value on our end) ## Editing firewall rules You can add firewall rules to control what traffic is allowed to pass through the NordLayer tunnel. These rules will apply to inbound and/or outbound VPN traffic from all MX appliances in the Organization that participate in site-to-site VPN. To create a firewall rule, select Add a rule in the Site-to-site firewall section on the Security Appliance > Configure > Site-to-site VPN page. These rules are configured in the same manner as the Layer 3 firewall rules. You can add firewall rules to allow traffic from the NordLayer dedicated server subnet (10.6.0.0/20) to your local network or services if you desire. ## Ending note: In order to finalize the site-to-site tunnel, please create a setup in [Sites tab of the NordLayer Control Panel](/v1/docs/site-to-site). - Pre-shared key - you can generate it or we can provide it - Encryption  details (AES, SHA and DH group) - AES256, SHA256 and DH group 14 are recommended (also must support [IKEv2](https://nordlayer.com/learn/vpn/ikev2/)) - Remote gateway/router public IP (must be reachable while connected to the dedicated server) - Remote subnet and mask (the subnet is used in your local network) --- **Note**: In case you have any questions or issues, press '**Chat with support**' at the bottom of the page.