--- title: "Setting up site-to-site on Synology | Nordlayer Helprouter" slug: "site-to-site-synology-router" description: "Follow the steps below to establish a Site-to-Site VPN connection between a pair of Synology Router." updated: 2026-09-08T13:06:52Z published: 2026-09-08T13:06:52Z canonical: "help.nordlayer.com/site-to-site-synology-router" --- > ## Documentation Index > Fetch the complete documentation index at: https://help.nordlayer.com/llms.txt > Use this file to discover all available pages before exploring further. # Setting up site-to-site on Synology router **Note**: If your device/service supports SHA256 and DH group 14, it is recommended to use these settings instead. ## Follow the steps below to establish a Site-to-Site VPN connection between a pair of Synology Router: 1. Set up your Synology Router and activate the Site-to-Site VPN feature on the SRM (refer to [this web page](https://www.synology.com/en-us/products/Site_to_Site_VPN_License) for more information on the licensing plan). 2. On your Synology Router, go to VPN Plus Server > Site-to-Site VPN. 3. Click Add > Manually. 4. Configure the settings at the General and Encryption tabs, and then save the settings. ## General - **Profile name**: NordLayer - **Pre-shared key**: Specify the pre-shared key that you would like to use - **Enable this connection**: Tick this checkbox to start the connection right after setup - **Enable DNSSEC validation**: Tick this checkbox to secure DNS resolutions via DNSSEC - **Local Site**: - **Outbound IP**: Specify one of the network interfaces on your Synology Router to set up the Site-to-Site VPN service. - **Local ID**: Specify a local ID, which can be either a public IP address or FQDN (Fully Qualified Domain Name). - **Private subnet**: Specify the local network under the private subnet - **Remote Site**: - **IP address/FQDN**: Enter your NordLayer dedicatated server IP address - **Remote ID**: Same as IP address - **Private subnet**: 10.6.0.0/20 - **Dead Peer Detection**: - **Enable**: Tick the checkbox to enable Dead Peer Detection (DPD). - **DPD Delay**: Specify the time interval between DPD packets. We use 30. - **DPD Timeout**: Specify a time threshold. We use 120. ## Encryption - **IKE version**: Select IKEv2 - **Mode**: Select Main Mode - **Encryption**: AES-256 - **Authentication**: SHA2-256 - **DH group**: 14 - **Key lifetime**: Specify how long the validity of your key is. Once the key expires, both sites will exchange a new key. Set to 28800. - **Enable Perfect Forward Secrecy (PFS)**: To be enabled ## Ending note: In order to finalize the site-to-site tunnel, please create a setup in [Sites tab of the NordLayer Control Panel](/v1/docs/site-to-site). - Pre-shared key - you can generate it or we can provide it - Encryption  details (AES, SHA and DH group) - AES256, SHA256 and DH group 14 are recommended (also must support IKEv2) - Remote gateway/router public IP (must be reachable while connected to the server with a dedicated IP) - Remote subnet and mask (the subnet is used in your local network) **Note**: In case you have any questions or issues, press '**Chat with support'** at the bottom of the page.